Advertisement
41.
Take the inside - to inside measurment between Top Wall Plates and Bottom Wall Plates at
the front middle and rear of your shed. These measurements should each be approximatley 91", but
more importantly, if they are not within 1/4" of each other than your walls are not square. Ensure walls
are square before attaching Ridge Boards together in Step 42.
42.
At the peak, align Ridge Boards so they are flush together and secure them with 8 - 1 1/4"
screws. To completely secure Ridge Boards, place 4 - 1 1/4" screws into any of the remaining Metal
Ridge Board Connector holes. Complete both sides. Important: if there is a gap between Ridge
Boards, try pushing side walls closer together from outside. Walls should be 91" apart at top from
inside of wall plate to wall plate.
Toll Free 1-888-658-1658
91"
91"
Metal Offsetting
Ridge Board
Connectors
www.outdoorlivingtoday.com
91"
Expert Advice: It may be helpful to use
some clamps to help hold Ridge Boards
flush together while screwing.
Page 21
sales@outdoorlivingtoday.com
Advertisement
