Advertisement
24.
Position and attach Door Header to Door Jamb
and Narrow Wall Panel top framing. Header should sit
flush with Door Jamb and Outside of Narrow Wall Panel
Siding Attach with 4 - 2 1/2" screws..
screws into perimeter
32"
Confirm Doorway Opening is 32" at top and bottom.
25.
When all walls are attached together, check alignment with the floor.
Bottom wall framing should sit flush with outside of floor joists. Confirm 32"
wide door opening at bottom. When positioned correctly, fasten bottom wall
plates to floor using 4 - 2 1/2" screws per wall panel.
Toll Free 1-888-658-1658
Bottom Wall
Angle
Framing
Floor Joists.
www.outdoorlivingtoday.com
Header has notch in edge that is
positioned to the top and facing outside.
Parts (Steps 24)
Door Header
(2" x 3 3/8" x 45 1/2")
Optional:
between bottom wall plates and
floor will help prevent moisture
from entering you shed. Caulking
not included in kit. This will help
the longevity of your shed.
Advice: Prior to fastening walls and installing
rafters, take time to confirm your walls are level,
square and plumb.
Measure diagonal at top and bottom of walls
corner-to-corner. This should be approximately
125 1/4". More importantly, if measurements
are not within 1/4", your walls are not square.
Adjusting now will make it easier to assemble
the roof section later
Page 14
Hardware (Steps 24)
S1 - 2 1/2" Screws
x 4 total
x 1
Caulking
seams
.
Hardware (Steps 25)
S1 - 2 1/2" Screws
x 32 total
sales@outdoorlivingtoday.com
Advertisement
