Cebora PLASMA PROF 164 HQC Instruction Manual page 59

®
Insert the other end of the connection art.. 1179 in the HV18 unit (art. 472) as shown on the left
side of the figure below:
The HV18 unit must be grounded directly on the pantograph (and fixed by 4 screws as shown in
par. 2.3), into a position that allows it to be opened.
Connect the connector art. 1189 and the pantograph connection to CN03 and CNC, respectively,
as shown in the following figure:
Fig. 3.3
Fig. 3.4
3300945-A
59
CN03
CNC