Cutting And Placing Thermal Pads - EK-Quantum Vector FE RTX 3070 Ti D-RGB + Backplate User Manual

CUTTING AND PLACING THERMAL PADS

Thermal Pad F – 1.0 mm (120 x 16 mm)
120 mm
STEP 1
Your GPU water block comes with thermal pads that have to be cut
into smaller pieces to cover all the VRM components, such as COILs,
MOSFETs, and drivers.
1 mm
Replacement thermal pads:
3x Thermal Pad F 1.0 mm – (120 x 16 mm) EAN: 3830046996732
STEP 1
STEP 2
Thermal Pad F 1.0mm
Once cut to size, thermal pads should be placed on the PCB, as
illustrated below. EK made sure to provide you with more than an
adequate quantity of thermal pads to complete this Step.
STEP 2
- 9 -
You must remove the protective foil from both sides of the
thermal pad before installation.