Canon DADF-J1 Service Manual page 45

c. Slide Guide Positioning Member
The rail of the slide guide is provided with notches to make sure that the slide guide stops
to suit a specific default original size. Some of these points representing differing paper
sizes, however, are close enough to allow the slide guide to be set at the wrong point.
To prevent wrong positioning of the slide guide, the DADF comes with two types of slide
guide positioning members; when fitted correctly, the positioning members will make sure
that the slide guide will stop at the correct point.
Color of slide guide positioning
member
Gray (for A/B-configuration)
Black (for Inch-configuration)
Slide guide
positioning
members (black)
Slide guide
positioning member (gray)
COPYRIGHT © 2001 CANON INC.
Side with 1 notch
A4R
LTRR
T02-203-07
For Inch-configuration
For A/B-configuration
F02-203-07
2000 2000 2000 2000 CANON DADF-J1 REV.0 MAR.2001
CHAPTER 2 OPERATIONS AND TIMING
Stop position of slide guide
Side with 2 notches
A4R
LTRR
LTRR
A4R
Relocate.
Relocate.
Slide guide positioning
member (gray)
2-23