Gasboy Islander PLUS Installation Manual page 111

Fault Probable Cause
Doesn't accept OrPT setup is
Key/Card/Keypad incorrect
input
No
OrCU setup is
communication
incorrect
No Magnetic Dirty or faulty
Card response Magnetic Card
reader
Faulty Magnetic
Cards
No Key response Loose cable
Faulty key
receptacle
Customer display Faulty Customer
is blank display
Faulty OrPT
Pump does not Device is not
supply fuel allowed to refuel
Islander PLUS Manual
Table 5-1. Islander PLUS Troubleshooting (Cont'd)
Checks
System is down (Continued)
Login into OrPT and
check communication
parameters
Check OrCU setup:
• OrPT bus
• OrPT parameters
• OrCU Administrator
1. Visually check
2. Present several
1. Visually check Key
2. Insert several keys
Verify that customer
display board is properly
connected to OrPT
interface board
Mechanic pump does not refuel
1. Open the pump from
2. Verify that the
parameters
Magnetic Card reader
Magnetic Cards
receptacle
SiteOmat Status
screen
vehicle/device has no
limitation in FHO
setup
Corrective Action
1. Set communication
parameters
2. Submit and check again
1. Set communication
parameters
2. Save and reload
3. Check again
1. Clean Magnetic Card
reader
2. Replace Magnetic Card
reader
3. Replace OrPT
1. Replace Key receptacle
2. Replace OrPT
1. Replace customer
display
2. Replace OrPT
Enable the device to refuel
97