Table of Contents
Advertisement
Connection diagram for sensors without control
cable. With and without temperature compensa-
tion
Scaling and offsetting the output
Scaling the analog output
The output is scaled linear from minimum to maxi-
mum and it is done in the HB-tool.
Offsetting minimum and maximum
If your sensor height doesn't match your vessel height
it is possible move the minimum level and maximum
level beyond the physical sensor by adjusting the off-
set value in the HB-tool. It is also possible to make the
offset by making a calibrations to known levels also in
the tool.
Wire level sensor manual 05
1
+24V DC
2
Not used
3
Not used
4
AO, 4-20 mA level
5
Not used
The sensor with ATEX approval use a two wire connection.
This means only two pins in the M12 connector are active
and the output is a 4-20 mA analog signal.
Analog output
mA
20
4
Minimum level
Suited for
•
HBLT and HBLT-wire & Flex
•
HBLC
Barrier
October 2021 HBproducts.dk
+
PLC
AI
AO
AI
DO
Level
Maximum level
12
Advertisement
Table of Contents
