Riello 20147241 Instruction Booklet page 3

Helioterm inverter recessed control panel
Table of Contents

Advertisement

HELIOTERM INVERTER
Ai fini del fissaggio, basterà semplicemente eseguire le
seguenti operazioni:
 Effettuare i collegamenti come descritto al capitolo
"Collegamenti"
e
nel
dell'apparecchio.
 Alloggiare il regolatore e relativa armatura nella scatola
a tre moduli precedentemente incassata nel muro e
fissare (in posizione A) mediante le viti fornite a corredo
Montare a pressione la PLACCA desiderata (P).
L'armatura è stata studiata per montare sul prodotto una
serie di PLACCHE ben specifiche:
 BTicino serie LIVING
 AVE serie sistema 45
 Vimar serie IDEA
In base alla placca selezionata è necessario, in alcuni casi,
intervenire sulle quattro linguette laterali.
Per montare la placca della BTicino serie Living Classic 4713-
-, occorre asportare le linguette evidenziate nel disegno
con la lettera B all'altezza del punto 1.
Se si utilizza una placca della Vimar serie Idea è necessario
tagliare le linguette B all'altezza del punto 2 posto a circa
1 mm dall'accenno di taglio situato sulle linguette stesse.
Infine se si utilizza una placca Ave non è necessaria alcuna
operazione di adattamento.
SI
1,5 m
IT
manuale
di
installazione
NO
NO
In order to fix it, therefore, only the following operations
are necessary:
 Connect as described in the "Connections" section and
in the installation manual for the device.
 Position the regulator and its housing in the three-
module casing previously recessed in the wall and fix
the assembly (in A position) using the screws provided.
Press to fit the desired COVER PLATE (P).
The housing has been designed for fitting a very specific
series of COVER PLATES on the product:
 BTicino LIVING series
 AVE sistema 45 series
 Vimar IDEA series
According to the selected frame it is necessary, in some
cases, to operate on the four side wings.
For installation with the BTicino Living, Classic 4713--,
series frame, side wings B must be cut along line 1.
If using a Vimar frame (Idea series) it is necessary to cut
the side wings B along line 2 in.
With an Ave Sistema 45 frame no adapting operation is
required.
P
3
EN
A
B
2
1
Doc-0089524 Rev. 4

Advertisement

Table of Contents
loading

Table of Contents