Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Bornack STRIPE BASIC
Summary of Contents for Bornack STRIPE BASIC
- Page 1 STRIPE BASIC User Manual 0123 EN 361:2002...
-
Page 2: Brief Description
Full body / rescue harness Subject to technical changes BRIEF DESCRIPTION INTENDED USE The STRIPE BASIC full body harnesses are part • Arresting of the personal protective equipment (PPE) of • Restraining on the fall edge Category III to protect against falls from a •... - Page 3 • Press stud for attachment of V-PROTECT USEFUL LOAD The maximum number of users is 1 person. The arrester harnesses of the STRIPE BASIC series were tested and certified for applica- tion cases in which the energy-absorbing connecting equipment (e.g. in compliance...
- Page 4 4 | 5 Rear D-ring Shoulder strap Identification/Label Front anchorage loop Chest strap EASY GLIDE Buckle Fastener depending Press-stud for V-PROTECT on model - Back-loading fastener - CLICK fastener Strap end - CLICK LIGHT fastener storage Seat harness Leg loops...
-
Page 5: Information Before Use
• Can you see or feel any damage in the textile repaired in a workshop authorised in writing by components? BORNACK. • Are there any signs of damage to the fittings, • Regular inspections are essential because the D-rings, buckles, karabiners? Are they bent? safety of the user depends on the efficiency and •... - Page 6 6 | 7 STRIPE BASIC IN USE PREPARATION Attach V-PROTECT. Check the size setting. Observe/read the V-PROTECT User Manual. A Lift the arrester harness on the rear arresting D-ring. All harness fasteners need to be open. Harness must hang freely and may not be...
- Page 7 STRIPE BASIC IN USE Check the fit of the arrester harness. The shoulder harness and leg straps should be flush to the body but not too tight. The shoulder harness straps should be set to the same length. The rear arresting D-ring must sit centrally between your shoulder bla- des.
- Page 8 8 | 9 BELT FASTENERS IN USE EASY GLIDE CLICK BUCKLE This buckle only serves to adjust the length of the straps: • Tilt the buckle. • Pull the open strap to tighten until the requi- red position is reached. To release/loosen the buckle, tilt and then pull it.
- Page 9 STRAP END STORAGE IN USE STRAP END STORAGE The strap end storage device serves secure storage of the free strap ends. • Wind the strap outwards around the storage clip until approx. 1 cm from the strap fastener or the buckle. •...
-
Page 10: Safety Instructions
C a s u a l t i e s m u s t b e r e s c u e d w i t h i n course. To this end, make use of the training 20 minutes. BORNACK can help you draw up competence of the BORNACK training centres: tailor-made rescue plans and includes these info@bornack.de. -
Page 11: Maintenance
• The dealer must ensure that the User Manual is supplied in the language of the designated country. The respective translation must be authorised by BORNACK. SERVICE If you have any further questions about this PPE or other BORNACK services, such as:... - Page 12 For more details, please visit www.bornack.de necessary. REPAIRS LIFE SPAN • Repairs may only be carried out by BORNACK The following recommendation applies for the or in a workshop authorised in writing by use of the STRIPE BASIC arrester harnesses: BORNACK.
- Page 13 OTHER STORAGE • Dry damp PPE before storage. • Store in a dry place away from direct sunlight. • Do not store PPE near radiators. Permanent exposure to temperatures below 0 °C or above +50 °C has a negative impact on the strength of the textile material and shortens the life span.
-
Page 14: Product Identification
14 | 15 OTHER PRODUCT IDENTIFICATION The following identification is on the product: CE symbol Product name Logo Product type Product type Data matrix Size Article No. EN Norm Charge Serial no. Read / Production observe the date user manual Manufacturer address... -
Page 15: Eu Declaration Of Conformity
EU DECLARATION OF CONFORMITY... -
Page 16: T E S T C A R D
Serial no.: _________________________ expert from his decision about the overall condition. Purchase date: ______________________ Manufacturer: Date of first use: _____________________ BORNACK GmbH & Co.KG info@bornack.de Life span end at the latest: _____________ www.bornack.de Application scope :___________________ Next Date Signature Inspection... - Page 17 T E S T C A R D FOR ANNUAL MONITORING Please complete: year year year year year year year year year year Straps undamaged? Seam patterns undamaged? Strap ends secured/sewn down? Fixture parts complete and undamaged? No deformation of metal parts? Plastic parts complete and undamaged?
- Page 18 18 | 19 Notes:...
- Page 19 Notes:...
- Page 20 Tel + 49 (0) 70 62 / 26 90 0-0 Fax + 49 (0) 70 62 / 26 90 0-550 info@bornack.de www.bornack.de © BORNACK –Subject to technical changes Reprinting, even of excerpts, is only permitted with written consent Status: 06/2021 GAL Art.-Nr. 8000011_EN ebo...