Notes For Installation; Requirements - Bartec Agile X IS Installation Instruction

Notes for installation

2 Notes for installation
ATTENTION
Property damage through interrupted power supply!
Verify that Tablet PC is running on AC power during the entire update process. Do not unplug the AC

adapter or any other connected external devices during the update process.
Do not perform any actions on the Tablet PC during the installation that could interrupt the installation

process. Do not restart or turn off the Tablet PC during the installation as it may cause permanent
damage to the Tablet PC.
2.1

Requirements

3/9
Agile X IS
Installation instruction: Windows 10 IoT Enterprise operating system
The instructions in this Installation instruction are valid for following devices and operating
system version
Device
Operating system
Operating system version
Operating system name
BARTEC
Build number
BARTEC
Requirements for the Agile X IS series to install the operating system:
1. Tablet-PC Agile X IS
2. Docking Station 03-9914-0022 for Tablet PC Agile X IS (recommended)
3. Power supply 03-9911-0040
4. AC power cable
5. USB stick with operating system
Standard non-Ex USB stick (8 GB or higher)
Attention: A standard non-Ex USB stick must not be used on the Ex i USB port of the
Agile X IS!
Alternative:
USB stick (Ex i; 8 GB) with the Windows 10 IoT Enterprise operating system of
BARTEC
Tablet PC Agile X IS
Type: 17-A1B*-****/********
Windows 10 IoT Enterprise LTSC
Version 2019
Build 1809
XISLTSC19R01
113
Subject to technical changes. Subject to technical changes.
12/2021 09/2020