Data Report - netvox R718E User Manual

Three-axis digital accelerometer & ntc thermistor

Hide thumbs Also See for R718E:

User manual (14 pages)

User manual (8 pages)

Table Of Contents

Sleeping Mode

The device is on and in the

Sleeping period: Min Interval.

network

When the reportchange exceeds setting value or the state changes: send a data report according to Min Interval.

First two mins: wake up every 15 seconds to send request.

The device is on but not in

After two mins: enter sleeping mode and wake up every 15 minutes to send request.

the network

Note: Suggest to remove batteries if the device is not used.

Low Voltage Warning

Low Voltage

3.2V

5. Data Report

When the device is turned on, it will immediately send a version package and a cluster report data.

Data will be reported once per hour by default setting.

Maximum time: 3600s

Minimum time: 3600s (Detect the current voltage value every 3600s by default setting)

Default reportchange:

Batteryvoltagechange ---- 0x01(0.1V)

Acceleratedspeedchange ---- 0x03(m/s²)

Remarks:

1. The device data sending cycle depends on the burning configuration before shipment.

2. The interval between two reports must be the minimum time.

·R718E to report three-axis acceleration and speed

The device's three-axis acceleration exceeds the set active threshold and a report is issued immediately. After reporting the three-axis acceleration and

speed, the three-axis acceleration of the device needs to be lower than the set static threshold and the duration is longer than 5 seconds (not modifiable)

before the next detection can be started. If vibration continues to occur during this process. The timing starts again.

The device sends two packets of data, one for three-axis acceleration, one for three-axis speed and temperature, and interval between two packets are

10 seconds.

Note: MinInterval is the sampling period for the Sensor. Sampling period >= MinInterval.

he reported data is decoded by the Netvox LoRaWAN Application Command document and

Data report configuration and sending period are as following:

Description

Device

CmdID

ConfigReportRe

ConfigReportRs

R718E