Wacker Neuson DS70 Operator's Manual page 28

Operation
Continued from the previous page.
Operating the Perform the procedure below to operate the rammer.
machine
1. Move the throttle to the full / fast position (c3).
2. Guide the rammer's direction of travel. Allow the rammer to pull itself forward.
Do not try to overpower the rammer.
CAUTION
Do not lift or move the rammer to another location while it is operating. You may
lose control of it.
Stop the engine before lifting or moving the rammer to another location.
Restart the engine only after the rammer is in place.
Safe For best compaction and shoe wear, the shoe must hit the ground flat (d), not on
operating
its toe or heel.
practices
Guide the rammer in such a way that you are not squeezed between the
rammer and solid objects.
Make sure you have solid footing when operating the rammer on uneven ground
or when compacting coarse material.
Stopping the 1. Place the throttle in the slow / idle position (c2).
machine
2. Stop the engine by moving the throttle through the detent to the off position (c1).
3. Close the fuel valve.
d
wc_gr008978
28
DS 70
wc_tx003057gb.fm