Battery - APRILIA RS 660 2020 Manual

•
Unscrew the cap (12) and remove together with the gasket (13).
•
Top up the reservoir (11) with recommended brake fluid to above the mini-
mum level marking "MIN".
CAUTION
ONLY FILL TO THE "MAX" LEVEL AFTER FITTING NEW BRAKE PADS. DO NOT
FILL TO THE "MAX" LEVEL WITH WORN PADS, AS THIS WILL CAUSE FLUID
04_12
TO ESCAPE WHEN REPLACING BRAKE PADS.
CHECK BRAKING EFFICIENCY.
IF THE DEAD ZONE OF THE BRAKE PEDAL OR BRAKE LEVER IS TOO LONG,
OR IN CASE OF FLUID LOSS, IT MAY BE NECESSARY TO BLEED THE AIR
TRAPPED IN THE SYSTEM.
HAVE THIS PROCEDURE PERFORMED BY AN Authorised Aprilia Dealer.

Battery

NOTE
THIS VEHICLE IS EQUIPPED WITH A LITHIUM BATTERY.
ONLY USE THE VEHICLE WITH A TEMPERATURE RANGE FROM -20°C TO +55°
C (-4°F TO +131°F).
IN CASE OF CONTINUED USE AT TEMPERATURES NOT WITHIN THIS RANGE,
INSTALL A YUASA YT12A-BS LEAD BATTERY.
IF THE VEHICLE FAILS TO START AT TEMPERATURES BELOW 0°C (32°F), TRY
AGAIN REPEATEDLY, TO WARM THE BATTERY UP TO OPERATING TEMPER-
ATURE, UNTIL THE ENGINE STARTS.
151