Gold's Gym CYCLE TRAINER 400 R User Manual page 9

4. Orient the Upright (3) as shown.
Tip: Avoid pinching the Main Wire (31). Attach
the Upright (3) to the Front Frame (1) with four
M8 x 16mm Screws (35). Start all the Screws,
and then tighten them.
Locate the wire tie in the Upright (3). Tie the
lower end of the wire tie to the Main Wire (31).
Then, pull the upper end of the wire tie until the
Main Wire is routed through the Upright.
Tip: To prevent the Main Wire (31) from fall-
ing into the Upright (3), secure the Main Wire
with the wire tie.
Insert the excess Main Wire (31) into the
Upright (3).
5. Orient the Rear and Front Shield Covers (9, 19)
as shown.
Press the Rear and Front Shield Covers (9, 19)
together around the Upright (3), and join them
with two M4 x 12mm Screws (61).
Then, press the Rear and Front Shield Covers
(9, 19) downward onto the Left and Right Shields
(17, 18).
4
Wire Tie
Wire Tie
Avoid pinching
the Main Wire (31)
5
61
9
9
3
35
1
31
19
3
17, 18
61