Storing The Shear; Troubleshooting; Routine Maintenance; Replacing The Blade - CAMPAGNOLA Speedy Use And Maintenance Manual

•
Carefully put the shear into its packaging.
5.3

Storing the shear

•
Keep the trigger pressed for few seconds until you hear 3 long beeps. The blades close and remain closed. Release the
trigger.
•
Switch the shear off and remove the battery.
•
Recharge the battery before putting it into its box.
•
Clean the shear and put it back with its components into its box.
•
Store the shear in a dry place.
•
For long periods of inactivity recharge the batteries not later than every 3 months.
5.4

Troubleshooting

WARNING!
All the following maintenance operations shall be carried out by a maintenance technician.
FAULT
The shear cannot complete the cut.
The battery does not get completely re-
charged.
Electric/mechanical wrong functioning
The tool does not work.
WARNING!
Failure to apply the instructions described in this manual could cause damages or injuries.
6.1

Routine maintenance

WARNING!
• Before carrying out any routine maintenance operation, put the ON/OFF button (5) in "OFF" position and remove
the battery (12) from the tool.
•
All the maintenance operations which are not mentioned in this manual must be carried out at an Authorized
Service Point.
Routine maintenance operations can be carried out by the operators.
6.2

Replacing the blade

If the cutting blade (1) is worn or if the shear does not guarantee a clean cut after its sharpening, it is advisable to replace
the blade group by following the steps mentioned below.
WARNING!
Before any maintenance operation switch off the shear and remove the battery.
Page 26
CAUSE
The branch diameter is over 25 mm or
the wood is too hard
•
Degraded battery
•
Faulty battery charger
•
Unsuitable battery charger
•
Motor overheating
•
The shear makes noise
Possible electronic or mechanical
problem
REMEDY
Immediately release the trigger. The
cutting blade will go back to its open-
ing position.
•
Check that the battery charger is
the one supplied with the shear.
•
Replace the battery.
•
Replace the battery charger.
Contact an Authorized Service Point
Contact an Authorized Service Point
Use and maintenance manual – Translation of
original Instruction.: 00, Date 10/10/2019