General Information
COMPONENT ACCESS
FIG. 8: To open a drive shield (1), lift all the way up on
the handle (2) and push the drive shield forward.
To close a drive shield, pull rearward on the handle and
lower all the way down. Make sure the drive shield's lower
lip is behind the support channel.
FIG. 9: To open a cutterbed hood (1), lift the hood all the
way up. Make sure the hood support (2) is engaged into
the notch (3) in the center hood.
To close a cutterbed hood, lift the cutterbed hood slightly.
Lift the hood support out of the notch in the center hood
and lower the cutterbed hood. Make sure the cutterbed
hood is all the way down and the curtains are held closed
by the magnets.
02-8
1
FIG. 8
2
FIG. 9
2
M811965
1
3
NC19322
4283362M2