Component Access; Bolt Torque Values - MASSEY FERGUSON 9070 Workshop Service Manual

COMPONENT ACCESS

FIG. 7: To open a top drive shield (1), pull the rubber
latch (2) out of the catch. Lift the drive shield all the way
up.
To close a drive shield, put the drive shield in the closed
position. Install the rubber latch in the catch.
FIG. 8: To open a cutterbed hood (1), lift the hood all the
way up. Make sure the hood support (2) is engaged into
the notch (3) in the center hood.
To close a cutterbed hood, lift the cutterbed hood slightly.
Lift the hood support out of the notch in the center hood
and lower the cutterbed hood. Make sure the cutterbed
hood is all the way down and the curtains (4) are held
closed by the magnets.

BOLT TORQUE VALUES

All bolts used on this machine are Grade 5 plated bolts
unless specified. Always replace with Grade 5 hardware
except where higher grades are specified. All Grade 5
bolts have three radial marks on the bolt head.
DO NOT over tighten bolts as this can cause a bolt to fail
during operation.
See the Specifications section for bolt torque charts.
See the Specifications section for wheel hardware torque.
4283063M1
GENERAL INFORMATION
1
FIG. 7
1
3
FIG. 8
2
LA27102
2
4
KB18953
2-7