Initialisation Of The Deskline Parallel System - Linak DESKLINE DL12 User Manual

Initialisation of the DESKLINE parallel system

The DESKLINE system is initialised by pressing the down button once or twice and holding it down until the DB/DL runs into
end stop. It will then automatically run approx. 5 mm out again and hereafter slowly run in again. Only release the down
button when the movement has stopped completely.
If the button is released before the sequence is completed, the initialisation is interuppted and must be started again
from the beginning.
The first two times the system runs into the outward end stop, it will automatically run approx. 3 mm back in inward direction.
The CBD5 and the CBD6 can control the DL5 and the DL6 in 2 parallel while the CBD4 can control the DL5 and the DL6 in 2,
3, and 4-parallel so that the desk is always kept horizontal.
Page 21 of 36