Mounting Foot; Mounting Guidelines For The Dl17 System; Mounting Top - Linak DESKLINE DL12 User Manual

Mounting guidelines for the DL17 system

Mounting top

The top of the column is supplied with 4 x M6 threaded
holes meant for mounting onto the desk frame . We advise
you to fasten the desk frame by means of 4 x M6 screws
of a good quality (min. 8.8) and of a suitable length of
minimum 10 mm and must not go into the column further
than maximum 14 mm. The screw torque must not exceed
10 Nm
Top Plate
As the desktop amplifies the sound, we advise you to place a vibration/shock absorbing material between the desktop
and the desk frame.
Bottom Plate
MC 6
MC 6
MC 8
(Example of how to mount the DESKLINE

Mounting foot

The DL17 is supplied with 4 x M6 threaded holes and 2 x
M8 screws for mounting of the foot. You can use either 2 x
M8 screws or 4 x M6 screws dependent on your foot design.
We advise you to use screws of a good quality min. 8.8 and
of a suitable length, which must not go into the DL7 column
further than 16 mm. The screw torque must not exceed 10 Nm
in the bottom plate thread.
The holes in the foot ought to be sufficiently larger than
(1)6 so that it is possible to bring the foot to a level line at
assembly/mounting of the table.
MC 6
system)
®
Page 15 of 36
MC 6
Bottom Plate
MC 8