Culligan Medallist Series Installation And Operation Instructions With Parts List page 19

4 English or Metric
Press the "STATUS" key. The display will blink "dIP5" for 3 seconds and then
show the current status. Toggle between "En" (English units) and "MET" (Metric
units) with the "+" or "-" key.
5 12 or 24 Hour Clock
Press the "STATUS" key. The display will blink "dIP6" for 3 seconds and then
show the current status. Toggle between "12 Hr" (12 hour clock) and "24 Hr"
(24 hour clock) with the "+" or "-" key.
Setting the Microprocessor
The microprocessor senses when it is installed as a Soft-Minder
automatically reset the microprocessor to the factory settings.
Step 1 – Programming Time of Day
Press the "STATUS" key.
The display will blink "tod" for 3 seconds and then change to time of day with the
"ones" digit blinking.
Adjust the "ones" digit with the "+" or "-" keys.
Press the "REG" key to blink the "tens" digit.
Adjust the "tens" digit with the "+" or "-" keys.
Press the "REG" key to blink the "hours" digit.
Adjust the "hours" digit with the "+" or "-" keys.
Press the "REG" key to cycle back to "ones" or
Note: The "hours" setting scrolls through 1-12 AM and 1-12 PM. Make sure the proper AM or PM indicator is shown when setting
the time. No indicator will be shown for AM.
Step 2 – Programming Regeneration Time
Press the "STATUS" key after setting the time of day.
The display will blink "tor" for 3 seconds and then change to the time setting with the
"ones" digit blinking.
Adjust regeneration time as time of day above.
Note: This option will not show if the "dIP 2" option is set to immediate
Step 3 – Programming Backwash Time
Press the "STATUS" key after setting regeneration time.
The display will blink "bw" for 3 seconds and then display the backwash time in
minutes.
Adjust the setting with "+" or "-" key. (1-40 minutes)
®
control. Adding or removing any connection to the board will
PM
PM
12:00
2:00
10
Programming 16