Removing/Installing The Footboard Assembly; Removing; Installing - Invacare Pronto M71 Service Manual

3. Secure the telescoping front tube to the side rail at the desired depth with the existing
two cap screws, spacers and threaded blocks.
4. Repeat STEPS 1 to 3 on the opposite side if desired.
Side Rail
Cap Screws
FIGURE 7.8 Adjusting/Replacing Telescoping Front Rigging Supports - Adjustable ASBA Seat

Removing/Installing the Footboard Assembly

NOTE: For this procedure, refer to FIGURE 7.9 on page 72.

Removing

1. Remove the quick release pin that secures the footboard assembly to the wheelchair
frame by depressing the button while sliding the pin out.
2. Remove the footboard assembly from the wheelchair frame.

Installing

Make sure the detent balls are engaged with the outer edge of the tube - otherwise,
injury and/or damage may result.
1. Position the footboard assembly onto the wheelchair frame so that the mounting holes
in the wheelchair frame align with the desired mounting holes in the footboard
assembly.
2. Install the quick release pin by depressing the button while sliding the pin IN. Make
sure the detent balls are engaged with the outer edge of the tube.
Part No 1118377
All manuals and user guides at all-guides.com
SECTION 7—FRONT RIGGINGS/FOOTBOARD
Spacers
WARNING
71
Side Rail
Spacers
Threaded
Blocks
Cap Screws
Telescoping
Front Tube
Pronto® M71™