Invacare Pronto M71 Service Manual page 39

8. Pull both side rails off the crossbars.
Installing Side Rails
1. Install new side rails onto crossbars.
NOTE: Ensure long end of side rail is towards the front of the wheelchair.
2. Secure the side rails to the crossbars with the hex screws, washer and lanyard. Torque
to 75 in-lbs.
3. Slide cane brackets (with T-nuts and back assembly) into the slots in the side rails.
4. Slide front arm sockets (with T-nuts) into the slots in the side rails.
5. Use a rubber mallet to tap the two roll pins into the side rails.
6. Tighten the four hex screws to secure the cane brackets to the side rails. Torque to 13
ft-lbs.
7. Install the armrests.
NOTE: It may be necessary to slide the front arm sockets to the proper position to install the
armrests.
8. Tighten the four hex screws to secure the front arm sockets to the side rails. Torque to
13 ft-lbs.
Back
Cane
Side Rail
Roll
Pin
Hex Screws
Part No 1118377
All manuals and user guides at all-guides.com
Side View
Crossbar
Washer
FIGURE 4.7 Removing/Installing Side Rails
39
SECTION 4—SEAT ASSEMBLY
Cane Bracket Front Arm
Socket
Slot
Hex Screws
Pronto® M71™