Removing/Installing The Footboard Assembly; Removing; Installing - Invacare Pronto M41 Service Manual

Removing/Installing the Footboard Assembly

Pinch point may occur when rotating the footboard assembly.
NOTE: For this procedure, refer to FIGURE 7.7.

Removing

1. Remove the quick release pin that secures the footboard assembly to the wheelchair
frame by depressing the button while sliding the pin out.
2. Remove the footboard assembly from the wheelchair frame.

Installing

Make sure the detent balls of the quick-release pin are fully released beyond the
outer edge of the tube before operating the wheelchair. Otherwise, injury and/or
damage may result.
Keep detent balls clean.
1. Position the footboard assembly onto the wheelchair frame so that the mounting hole
in the wheelchair frame aligns with the desired mounting hole in the footboard
assembly.
2. Install the quick release pin by depressing the button while sliding the pin in. Ensure
that the detent balls are engaged with the outer edge of the tube (Detail "A").
Mounting
Hole
Quick Release Pin
FIGURE 7.7 Removing/Installing the Footboard Assembly
Part No 1145724
SECTION 7—FRONT RIGGINGS/FOOTBOARD
WARNING
WARNING
Shroud
Footboard
Assembly
Detent
Ball
49
DETAIL "A" - TOP VIEW
OF FOOTBOARD
Outer Edge of Tube
Detent Balls
Release Pin
Quick
®
Pronto M41