Searching The Access Point And Setting Up A Wireless Network - Sony Giga Juke NAS-SC500PK Operating Instructions Manual

Searching the access point
and setting up a wireless
network
When using the supplied wireless adaptor and an
AOSS-incompatible wireless LAN access point,
you will need to set up the wireless network
either manually or by searching the access point.
Automatic setup is not possible.
1
Connect the supplied wireless
adaptor to a USB port on the unit.
2
Enter the Settings menu and select
[Network setting].
3
Select [Manual setting].
4
Select [Wireless LAN setting].
5
Select [Access point setting]
– [Search for available access point].
An SSID list of connectable access points
appears.
The SSID (Service Set Identifier) is used to
identify the access point within the wireless
network.
6
Select the access point from the
search results.
7
Set the network key.
A network key (security key) is required only
when [WEP], [WPA-PSK(TKIP)], [WPA-
PSK(AES)], [WPA2-PSK(TKIP)], or [WPA2-
PSK(AES)] appears as the security setting. If
you do not know the security key, check the
access point setting. After entering the key,
select [Save].
8
Select [Close].
The wireless network setting is completed.
To confirm if the unit is connected to
the network
Select [Check connections] in the network setting
display.
If the unit has difficulty connecting to the network,
check the access point setting and IP address
setting ("Confirming and changing the network
settings" on page 105).
Tip
You can set the access point manually by selecting
[Manual setting] in step 5.
101
GB