Table of Contents
Advertisement
7
Set the day of the week.
Press / to select the day and press ENTER.
Each time you press ENTER, the selected day
is checked or unchecked.
Confirm that the day you want to set the
On-timer is checked, select [OK], and then
press ENTER.
8
Select the source you want to play.
If you select [Yes], the currently playing
source will be played when the start time is
reached. If you select "SensMe™ Channels" as
the source, CH. 001 will be played no matter
which channel you select.
If you select Internet Radio as the source, the
station currently being received will be set.
If you select [No], the source that you set the
last time will be played.
9
Press VOLUME +/– to adjust the
playback volume.
If you select [Yes], the current volume is set
when the start time is reached.
If you select [No], the volume you set the last
time remains set.
"Confirm on-timer settings. " appears.
10
Select [OK].
The On-timer is set and
playback display.
3 minutes prior to the start time, the device
starts preparing for the On-timer playback.
20 seconds before the finish time, the volume
turns down gradually and the device goes into
standby mode automatically after the finish
time.
1
GB
Tips
If you do not want to set the finish time, set it to
While the On-timer is set in the HOME NETWORK
If the specified track is erased or the specified radio
If the time periods for the timer 1 and timer 2 overlap,
Notes
You cannot set On-timer in the Audio In function.
The On-timer setting is erased if you disconnect the
If the unit is already turned on 3 minutes before the
If the On-timer has been set, do not operate the unit
appears on the
[––:––].
function, the play mode changes temporarily to [1
repeat]. After completing the setting, the play mode is
restored.
station cannot be received before the On-timer starts,
an alarm sounds at the start time. Press any button to
stop the alarm. However, if you erase the specified track
or the unit is disconnected from the Internet within 3
minutes before the start time of the On-timer setting,
the alarm does not go off.
the timer which start time is set earlier than the other
one overrides the later one.
AC power adaptor.
start time of On-timer, the On-timer is not activated.
within 3 minutes of the start time. If you do, the On-
timer may not function.
Advertisement
Table of Contents
