Table of Contents
Advertisement
Updating the system
application
By downloading the latest version of the system
application, you can take advantage of the newest
functions.
When a new update is available, you will be
notified by a message that appears in the display
while the unit is on and connected to the Internet.
Note
Make sure not to turn off the unit or disconnect the
network cable while the updating operation is in progress.
1
Enter the Settings menu and select
[Software update].
The system application update display
appears.
2
Follow the displayed instructions.
The updating starts. It may take about an
hour for the unit to finish updating.
After the unit finishes updating the
application, it will take about 30 to 40 minutes
before the unit restarts.
Formatting the system
This function formats the unit and restores it to
the condition it was in at the time of purchase.
Note that this process deletes all settings and
information (e.g., audio data recorded or imported
in the HDD Jukebox, clock setting and network
setting). However, system updates performed by
[Software update] are not deleted.
1
Enter the Settings menu and select
[System format].
A confirmation display appears.
2
Select [Yes].
Formatting starts.
The unit automatically restarts several times
during the operation. A few minutes after the
last restart, the unit turns itself off.
Moving track data
between the unit and other
components
You can move track data in the unit's HDD
Jukebox to other "GIGA JUKE" systems, or vice
versa. When you move the track data to another
"GIGA JUKE" system, the track data will be
deleted from the HDD Jukebox in the sender
system.
To use this function, the [Move track data] setting
must be provided in the Settings menu of the
sender and receiver systems. If not, the system
application should be updated (this page).
Sender system
HDD
Moving track data
Network
(LAN)
cable
Please read the following
It may take a while to move track data between
systems. For example, it takes about 20 hours to
move 5,000 tracks
You can stop moving of track data, then resume
moving from the point at which it was stopped.
Even after a transfer has been stopped, normal
operation will be possible on both systems (the
sender and the receiver).
Notes
When track data has been moved, the track data is
deleted from the sender system.
If you stop moving of track data, the track data that has
not been moved remains in the sender system.
Make sure not to turn off or reset the units (the sender
and the receiver) while a data moving is in progress.
Moving track data is not possible when the receiver
system is an older model than that of the sender system.
Track data can only be moved from an older model to a
newer model, or between the same models.
Receiver system
HDD
1
GB
Advertisement
Table of Contents
