Blade and anvil can be replaced separately. Do not worry about the blade positioning. It will put itself in the right position
after switching on the shear at the end of the replacement.
6.3
Problem solution
Number of short
Fault
beeps
1 beep
Reduced battery capacity
3 repeated beeps
Inefficient blade
4 repeated beeps
Interrupted connection to the motor
5 repeated beeps
Shorted motor
Continuous sound
Safety warning
6.4
Special maintenance
Any special maintenance operation, such as the replacement of the gear motor or of the main boards, must be
carried out at an Authorized Service Point.
AUTHORIZED SERVICE POINT
It is the Service Point authorized by the Manufacturer for repairing the products.
Page 32
Remedy
Check if the battery capacity is low.
Recharge the battery.
Lubricate the blade (see par. 5.2).
Contact an Authorized Service Point.
Contact an Authorized Service Point.
Check whether the operator's body is in contact with the shear
blade.
Use and maintenance manual – Translation of
original Instruction. : 04 date 16/09/2021