Related Manuals for Ecostrad Thermaglo
Summary of Contents for Ecostrad Thermaglo
- Page 1 Thermaglo Carbon Infrared Heater with Remote Ratings: AC 220-240V, 50/60Hz, 2000w, Class I, IP55 Rating...
- Page 2 Symbols Warning This symbol indicates a hazard with an average risk level which, if not avoided, could result in serious injury or death. Warning of electrical voltage This symbol indicates danger to the life and health of persons due to electrical voltage.
-
Page 3: Table Of Contents
Contents About the Device Technical Information Warnings & Precautions Installation Installation Restrictions 4-2 Fixings 4-3 Mounting Instructions 4-4 Installation with Stand Operation Control via Heater 5-2 Remote Control 5-3 Insert Batteries Maintenance Cleaning Troubleshooting Warranty 10 | Disposal Ecostrad_Thermaglo_V1.3_25062021... -
Page 4: About The Device
1 | About the Device The ECOSTRAD THERMAGLO carbon infrared heater produces instant, comfortable heat that feels like the warmth from the sun. These robust and weatherproof heaters are designed for domestic and commercial heating applications within indoor and outdoor areas. - Page 5 7. If an extension cable is used, ensure you select a cable which is rated to support the heater’s load. Extension cables that are rated too low to support the combined power of the appliances plugged into them can overheat and pose a fire risk. 8.
-
Page 6: Installation
the appliance by a person responsible for their safety. Children and vulnerable people should be supervised to ensure they do not play with the appliance. 24. Extreme caution is necessary when the heater is used in the vicinity of children or invalids. -
Page 7: Fixings
7. Do not install the heater on a flammable surface. 8. The heater should be mounted a minimum Ceiling Mounted Installation of 0.5m away from the ceiling and adjacent walls. 9. The heater must be kept a minimum of 1m away from people, animals, and flammable materials such as wood, cardboard and cloth. -
Page 8: Installation With Stand
Tools Needed: • Pencil • Hammer • Spirit level • Screwdriver • Power drill and drill bits 1. Fasten the brackets (1) together using the screws (6), washers (5) and wing nuts (4). (See Fig 1-2). 2. Line up the brackets with the wall or ceiling and mark the location of the four outer holes. -
Page 9: Operation
There is also a master power switch at the base of the heater. 5 – 2 | Remote Control All Ecostrad Thermaglo heaters and their remote controls have the same frequency, allowing multiple heaters to be controlled with one remote. -
Page 10: Maintenance
6 | Maintenance Careful and regular maintenance of the heater according to the instructions below is required to maximise the longevity and efficiency of your appliance. • Check the cleanliness of the heater at least once a month. If needed, follow the cleaning instructions below. -
Page 11: Troubleshooting
9 | Warranty The Ecostrad Thermaglo is supported by a 2-year guarantee covering the heater body and all electronic components, including the bulb. Within the stated period, starting from the date the customer receives their unit, Ecostrad guarantee to repair or replace the unit where a fault is due to defects in materials or manufacturing. -
Page 12: Disposal
Ecostrad. Photographs of the installation may be required to determine correct placement. If the unit has been hardwired, an invoice may be required to confirm the work was carried out by a qualified professional.