Advertisement
2. GENERAL SAFETy INFORmATION
This symbol means ATTENTION!
yOUR SAFETy IS INVOLVED.
The message that follows the sym-
bol contains important information
about safety. Carefully read the mes-
sage.
BEFORE SERVICING AND REPAIRING
. Read all safety instruction in this manual and
be aware of safety decal locations on your
machine.
2. Thoroughly clean your work area and the
machine.
3. Make sure the machine is on firm and level
ground and that the parking brake is set.
4. Lower the implement to the ground.
5. Stop the engine and remove the key.
6. Disconnect the negative battery cable.
7. Place a "DO NOT OPERATE" tag in the
operator station.
WORKING SAFETy
. Do not operate or service the machine while
under the influence of alcohol, medications,
or other sustances.
2. Never wear loose fitting clothing and always
use safety equipment appropriate to the job.
3. N e v e r u s e i m p r o v i s e d t o o l s, p a r t s o r
procedures. Use only recommended tools
appropriate to the work.
4. Extra care should be taken to work safely
when servicing is done by two or more
persons.
5. Always support the machine with safety
stands rated for the weight of the machine.
N e v e r w o r k u n d e r a m a c h i n e t h a t i s
supported solely with a jack.
6. Do not touch any rotating or hot parts while
the engine is running.
7. Escaping fluid (hydraulic oil) under pressure
can penetrate the skin causing serious
injury. Relieve pressure before disconnecting
hydraulic or fuel lines. Tighten all connections
before applying pressure.
DISPOSE OF FLUIDS PROPERLy
. Observe relevant environmental protection
regulations when disposing of oil. NEVER
pour fluids onto the ground, down a drain, or
into any body of water.
3. INSTALLATION INSTRUCTION
. Park the vehicle on firm and level ground.
Then, engage the parking brake and stop the
engine.
2. R e m o v e t h e s t e e r i n g w h e e l (A) a n d
instrument panel cover (B).
3. Remove the HST pedal (A) and floor mat (B).
Then, remove the middle floor (C), right floor
(D) and undercover (E).
- 3 -
CK3510(H)/4010(H)
TC2SZ01A
TC2SZ02A
TC2SZ03A
Advertisement
