Joining The Cases - Hussmann DM LOW HEIGHT Series Installation Manual

PRODUCT INSTALLATION MANUAL

Joining the Cases

Ensure cases are sealed before joining them to other cases
For instructions on attaching case ends, refer to appendix 4: attaching case ends
To join the cases
1. Draw up the required case tightly against the case already in position
2. Ensure that the case is level, from front to back and side to side, with the existing case.
3. Insert the joining bolts, found in the blister pack, into the end holes and tighten – see Fig (9): joining hole locations
_________________________________________________________________________________________________________________________
Page 9
CAUTION
Do not walk or sit on cases.
CAUTION
Case joining bolts should only be used,
with care, at the final pulling-up stage.
Fig (9) Joining holes location
DM13 FRONT OPEN MULTIDECK
Joining Holes
Hussmann