Operation; Loading Merchandise; Cleaning And Maintenance; Daily Checks - Hussmann DM LOW HEIGHT Series Installation Manual

PRODUCT INSTALLATION MANUAL

Operation

Loading Merchandise

Cases should only be stocked with merchandise for which they were manufactured as indicated by the case model number
on the rating plate (see Fig (18): Rating Plate) that is typically located, on the rear back panel at the lower right hand end
as viewed by the operator.
Use only fittings and accessories supplied with the case or approved by Hussmann.

Cleaning and Maintenance

Daily Checks

•
If an alarm system is not part of the refrigeration installation, the temperature of each case should be checked on
a daily basis via the thermometer that may be located in the left hand side of the ceiling panel, or via another reliable
method.
The case temperature should be in the range of 0C - 2C for both case types.
Up to three separate readings may have to be taken to ensure the case temperature isn't being taken during a
defrost cycle (which would give a higher than desired reading).
If it is consistently outside this range, contact Hussmann or your service contractor.
•
Visually check the case for damage or spills and take appropriate remedial action.
_________________________________________________________________________________________________________________________
Page 20
Fig (18): Rating Plate
CAUTION
Do not climb in or on the case as this may result
in personal injury and/or case damage.
CAUTION
If any damaged electrical components are
identified during inspection isolate case
power and contact service contractor.
DM13 FRONT OPEN MULTIDECK
Hussmann