Chapter 6 Recording - Mitsubishi Electric MELSEC iQ-R Series Introduction Manual

6
RECORDING
Operate the program of "Page 45 Creating a Program" and the GOT screen of "Page 53 Creating the Screen" to
perform recording, and read the recorded data from the camera recorder module.
Operating procedure
1.
Switch the CPU module to the RUN state. Check that the RUN LED and OPR LED of the camera recorder module turn
on.
The recording function automatically starts when the CPU module is switched to the RUN state.
2.
Open the program and intelligent function module monitor in GX Works3.
Right-click [(Target camera recorder module)]  [Register to Intelligent Function Module Monitor].
3.
Start monitoring (all the windows).
4.
Check if the recording function operates normally on the intelligent function module monitor.
5.
Turn on the switch (Cause 2) on the GOT.
6 RECORDING
55