Table of Contents
Advertisement
About the STATUS and WIRELESS
indicators
Standby indicator
When you plug in the power cord of the Network Media Receiver, the unit automatically initializes
itself and performs a hardware diagnosis routine. (This takes about 20 seconds.) When these steps
are completed successfully, the standby indicator lights up in red.
When you turn the Network Media Receiver on by pressing the POWER button on the remote
control or the power button on the front panel of the Network Media Receiver itself, the standby
indicator changes to green.
Note
If the standby indicator does not light up in red about 20 seconds after the power cord was connected,
contact the web site. See "Getting Help".
STATUS indicator
When data are being exchanged on the wired LAN or the wireless LAN, this indicator flashes in
green.
While the software is being updated, the indicator lights up or flashes in red. When the software
update process is completed, the indicator goes out.
During hardware diagnosis carried out when the power cord is first connected, the indicator
repeatedly flashes in red and green to indicate the progress status of the diagnosis routine.
WIRELESS indicator
When the Network Media Receiver is connected to a wireless LAN, it lights up in green.
During hardware diagnosis carried out when the power cord is first connected, the indicator
repeatedly flashes in red and green to indicate the progress status of the diagnosis routine.
60
Advertisement
Table of Contents
