Table of Contents
Advertisement
GE Medical Systems
Information Technologies
Error message C
HECK ELECTRODES
20% or ± 20 mA)
Defib Function Test and Pacer Option Test
The following tests are performed with the Service Tool (2006861-001). If the Dash Responder is
connected with a Dash Monitor this tests could also be done by means of the Dash Monitor.
Tests performed with the Test Tool
The below mentioned tests are performed when the Monitor
Interface Test described on page 22 will be performed.
Defib Tests
1. Periphery present test to Dash Monitor.
2. Charging Status Test.
3. Monitor Detection Test.
4. Communication test to Dash Monitor.
5. Synchronisation test for Signal from Dash Monitor.
6. Lead Fail/None Sync detection from Dash Monitor.
Pacer Option Tests
7. Pacer on/off test.
8. Pacer blank signal to Dash Monitor tested.
9. Detection of Telemetry ECG.
Battery conditioning test
On Dash Responder, switch Pacer- and SYNC- mode off.
Press both E
S
NERGY
ELECT
Revision F
2004768-001
appears when pulse current deviates from configured value (±
keys simultaneously, select S
Servicing Manual Dash Responder V1.0
Tests performed with the Dash Monitor
Set the Dash Monitor on top of the Dash Responder, connect
the ECG Simulator to the Dash Monitor and power it up with
AC, use a 5- or 12-Lead cable.
Defib Tests
1. Periphery present test to Dash Monitor
2. Charging Status Test
If C
LED lights yellow, both tests have passed.
HARGING
3. Monitor Detection Test
4. Communication Test to Dash Monitor
5. Synchronisation Test for Signal from Dash Monitor
Press S
key, if the S
YNC
YNC
lights yellow and will be switched off for short in the rhythm
of the heart rate the 3 tests have passed.
6. Lead Fail/None Sync detection from dash Monitor
Disconnect the RL (N) Lead, the message L
S
will appear on the Display of the Responder. The S
YNC
LED on the Responder turns off
Pacer Option Tests
7. Pacer on/off test
Switch pacer function on, and check, that the yellow P
O
/O
LED is on, and the corresponding display frame for
N
FF
Pacer will be displayed.
8. Pacer blank signal to Dash Monitor tested.
Set output to 5mA. Set pacer Mode so, that display shows
FIX and check that the Dash Monitor shows a 'P' and a
blinking '*' on its display.
9. Detection of Telemetry ECG.
No special test needed, if item 6 has been performed
successfully.
M
/ B
C
ERVICE
ODE
ATT
OND
LED on the Dash Responder
F
/N
EADS
AIL
ACER
.
Page 59 of 72
O
YNC
Advertisement
Table of Contents
