Matrix 320 With Manual Adjustable Focus (C-Mount); Step 0B - Assemble The Reader; Dl.code Illuminator Management Procedure; Step 1B - Connect The System - Datalogic Matrix 320 Product Reference Manual

MATRIX 320 WITH MANUAL ADJUSTABLE FOCUS (C-
MOUNT)

Step 0B - Assemble the Reader

For Matrix 320 700-030 (C-Mount), the first step to perform is to assemble the accesso-
ries that make up the reader. Refer to
and
Matrix 320 C-Mount Mounting Instructions, starting on page 68

DL.CODE Illuminator Management Procedure

1. Connect the reader to DL.CODE as
2. In the DL.CODE Device menu, click the
3. Click OK and at the device reset prompt

Step 1B - Connect the System

Refer to "

Step 2B - Mount and Position the Reader

Refer to "

Step 3B - Focus the reader

To focus the reader, refer to
Mount), starting on page 22
tance and go to "
described in this chapter.
Settings > Settings > Maintenance Set-
tings > Current Illumintor Model item
and select the illuminator being used
from the list.
click Yes and wait until the device
resets. You can confirm by reopening
this item from the same menu.
Step 1A - Connect the System" on page 1
Step 2A - Mount and Position the Reader" on page 3
, then place the reader at the factory focused Reading Dis-
Step 4 - X-PRESS Configuration" on page 6

MATRIX 320 WITH MANUAL ADJUSTABLE FOCUS (C-MOUNT)

Matrix 320 C-Mount Assembly, starting on page 46
.
Advanced Setup for Manual Adjustable Focus Models (C-
.
.
.
PRODUCT REFERENCE GUIDE
5