Datalogic Matrix 320 Product Reference Manual page 169

3. Now save them to a new Slave specific application job
Figure 94 - Saving Multidata Configuration to Slave 1
Repeat this procedure for each Slave device until the entire network is configured.
The following screenshots show the pass-through configuration settings.
1. If Save on Slave Device was selected when saving the Master configuration, an application
job with the same name (but with all Slave specific configuration parameters), has been saved
to the Slaves. No parameters have been cloned from the Master. There are no common param-
eters managed by the Master for Multidata configurations.
INTERNAL NETWORK CONFIGURATIONS
1
.
PRODUCT REFERENCE GUIDE
151