Quick Reference Guide - ElectrIQ CD12PRO-LE User Manual

Power Button: Press to turn the dehumidifier on and off.
Timer: Press the timer button, then use the
the timer (1-24 hrs, start/ stop timer).
If set while the unit is running: The number will represent the number of hours the unit will operate before
turning off. This will not be affected if the unit enters defrost mode or the tank is emptied and reinserted.
If set while the unit is in standby: the set number represents the period in hours after which the unit will
start. To cancel start / stop mode press the timer key again.
SMART Mode: This is designed for maximum convenience and defaults to the ideal
domestic environment humidity level of 50-55% while saving electricity. This is the
default mode and is recommended for most users.
During operation the compressor will operate until the desired humidity is reached and
then will stop. The fan moves the air around the room ensuring the entire air in the
room is processed and humidity correctly measured.
DEHUMIDIFY MODE: This is the standard operating mode, for which the desired humidity can be set using
the up and down buttons.
LAUNDRY MODE: When drying clothes it is advised for the dehumidifier to operate continuously with
maximum water extraction until the water tank is full. Do not place clothes directly over any of the vents on
the dehumidifier. Make sure that there is nothing blocking the hot air exhaust air flow and for best results
place the laundry within 1.5 meters of the dehumidifier.
NOTES:
•
If a permanent drainage pipe is fitted the unit will not stop operating. Setting the desired humidity to
around 35% is good for laundry mode, a quick drying boost, or in emergencies. It is not recommended
for long normal operation in a domestic or office environment.
•
To allow more moisture in the air, press the up button and set to a higher desired humidity (e.g. 60-
70%).
•
We recommend setting the Humidity to 50-55%. This is great for domestic operation and dry
storage.
•
Setting the humidity to 60% is great for personal comfort and applications where 50% RH is
considered too dry.
•
Setting the humidity to 70% is ideal for unoccupied properties or where an economical run is needed
without the need to reduce the humidity further.

QUICK REFERENCE GUIDE

Up and Down Buttons: During the High or Low modes when the unit is
displaying the current relative humidity, these buttons can be used to adjust the
desired humidity level. The desired relative humidity can be set between 35 and
80% in 5% increments.
10
buttons to adjust the duration of