Control Panel - ElectrIQ CD12PRO-LE User Manual

POWER Button
Turn the appliance on/off
POWER
MODE Button
Select the function of the unit between: SMART and FAN modes. The LED's
next to the button will show which mode is selected.
SMART MODE: The unit will default to SMART mode the first time it is
switched on and remains in this mode until another program is chosen. In
smart mode it will default to aim for a relative humidity of 50-55%.
AIR PURIFIER: Only the fan will run and water is not extracted. To be used
in conjunction with the optional filters. It can also be run without the filters to
work as a fan.
MODE
DEHUMIDIFY: The unit will remove moiseture from the air. The desired
humidity level can be set using the up and down buttons.
LAUNDRY: The dehumidifier will run continuously at high fan speed, to
remove the most moisture possible. This is ideal for drying clothes.
WIFI: Press and hold the WiFi button for 3 seconds to turn on the WIFI
function. See the WiFi Section for more information.
HUMIDITY SETTING
Press the UP and DOWN buttons to select the desired relative humidity
level, the default relative humidity is 55%. When a relative humidity of 35% is
UP / DOWN
selected, the compressor will not stop until the water tank is full.
HUMIDITY
HUMIDITY INDICATOR Button
When the appliance is started, the indicator light will turn on automatically.
The indicator light colour will change according to the humidity condition
RED: High humidity, RH≥70%
INDICATOR
ORANGE: Above ideal humidity, 70%> RH ≥60%
GREEN: Ideal humidity, RH<60%
Press and hold the SPEED button for 3 seconds to turn the humidity display
on and off.
Note: It can take around 2 minutes after the humidity has changed into a
different colour bracket for the indicator will change the colour e.g. if humidity
drops to 55% may take 2 minutes before the indicator changes to green.

CONTROL PANEL

7