MISSIONING THE CHILLER. FAILURE TO
PROPERLY PROGRAM THESE VALUES MAY
CAUSE DAMAGE TO THE CHILLER OR OP-
ERATING PROBLEMS.
NOTE: The type of refrigerant programmed must match
the refrigerant selected on the SW1 Dip Switch
on the Microprocessor Board. These selections
can be viewed by pressing the Options key (see
Section 3.7). If these two selections do not match,
the following message will appear:
The chiller will not operate until this situation is
corrected.
NOTE: Operation below 1°F may occasionally cause
nuisance low pressure safety shutdowns. This
will not cause a problem provided ambient tem-
perature is not expected to be below 1°F for
more than a short time.