Summary of Contents for Gilis Bebe Stars Evolution
Page 1
Group 0+/1 Car seat From 0 - 4years old Suitable for 0-18kg Evolution STANDARDS ECE R44/04 Your child’s safety depends on you. Proper baby car seat usage cannot be assured unless you follow these instructions. DO NOT USE YOUR BABY CAR SEAT UNTILL YOU READ AND UNDERSTAND THESE INSTRUCTIONS Η...
Page 2
WARNINGS / ΠΡΟΕΙΔΟΠΟΙΗΣΕΙΣ Please read this user guide carefully before Παρακαλούμε διαβάστε αυτό το εγχειρίδιο πριν την install the child seat and for future reference. εγκατάσταση του παιδικού καθίσματος . DO NOT USE THIS CHILD SEAT IN PASSENGER ΜΗΝ ΧΡΗΣΙΜΟΠΟΙΕΙΤΕ ΑΥΤΟ ΤΟ ΠΑΙΔΙΚΟ ΚΑΘΙΣΜΑ SEATS EQUIPPED WITH AIRBAGS.
Page 3
13.Always make sure that any straps holding the 13. Πάντα να είστε σίγουροι ότι οι ιμάντες που seat restraint to the vehicle shall be tight. Any συγκρατούν το κάθισμα στο όχημα πρέπει να straps restraining the child should be adjusted to είναι...
Page 4
VEHICLE APPLICATION / ΕΦΑΡΜΟΓΗ ΣΤΟ ΟΧΗΜΑ Correct fitting/suitable Incorrect fitting/not suitable Σωστή τοποθέτηση/κατάλληλο Λάθος τοποθέτηση/μη κατάλληλο This child seat is suitable for convection use in all cars equipped with 3-point seat belts that are fitted in accordance with European standard (ECE44 or equivalent standards) Αυτό...
Page 5
Always check that the shoulder straps are at the correct height for your child. The child’ s shoulders should always be thread through the slots in the cover and seat shell that are closest to the top of your child’s shoulders Πάντα...
Page 6
Step3. Then from the front of the Step4. Re-thread the harness strap back seat, pull it through the slot in the onto the harness connector at the back of seat’s backrest and fabric. the seat cover. Thread the harness strap back through the next hole up or down on Βήμα...
Page 7
TIGHTENING AND SLACKENING THE HARNESS / ΤΕΝΤΩΜΑ ΚΑΙ ΧΑΡΑΡΩΜΑ ΤΩΝ ΖΩΝΩΝ Tighten the shoulder harness / Τέντωμα της ζώνης Pull the shoulder straps upwards to remove the slack from the lap sections of the harness then pull the adjuster strap until the harness is fully tightened.
Page 8
RECLINE POSITION ADJUSTMENT / ΡΥΘΜΙΣΗ ΑΝΑΚΛΙΣΗ ΠΛΑΤΗΣ Note: Before fix a child in the child car seat, the seat must be set on the maximum recline position for rear facing use, or in the setting position for forward-facing. Only the maximum recline, it is rear facing for group 0+, the rest three reclination is forward facing for group 1.
Page 9
FITTING THE CAR SEAT WITH THE 3 POINT LAP & DIAGONAL SEAT BELT / ΤΟΠΟΘΕΤΗΣΗ ΤΟΥ ΚΑΘΙΣΜΑΤΟΣ ΜΕ ΖΩΝΗ 3 ΣΗΜΕΙΩΝ & ΚΑΙ ΤΗΝ ΔΙΑΓΩΝΙΑ Only use for group 0+ (less than 13kg) Μόνο για χρήση 0+ (εώς 13kg) Backrest Base Πλάτη...
Page 10
FITTING THE CAR SEAT WITH THE 3 POINT LAP & DIAGONAL SEAT BELT / ΤΟΠΟΘΕΤΗΣΗ ΤΟΥ ΚΑΘΙΣΜΑΤΟΣ ΜΕ ΖΩΝΗ 3 ΣΗΜΕΙΩΝ & ΚΑΙ ΤΗΝ ΔΙΑΓΩΝΙΑ Only use for group 1(9-18kg) / Μόνο για group 1(9-13kg) Step1. Place the baby car seat in front-facing position on the rear seat of the vehicle, adjust the baby car seat in the correct angle(same as the Fig.).
Page 11
MAINTENANCE TIPS / ΣΥΜΒΟΥΛΕΣ ΣΥΝΤΗΡΗΣΗΣ These instructions are important. Please read carefully and retain for future reference. Seat part cover removal. First, pull the plastic button at the back of the backrest cover off the backrest. Take out it from the back of the backrest cover. Slide the cover off. The covers can now be cleaned.
Page 12
European safety standards / Ευρωπαϊκά στάνταρντ ασφαλείας Αccording to the product’s quality, the requirements of the safety child seat is much more higher in the european country. The latest ECE R44/04 standards went into effect at June of 2006, the standard high tested by more realistic collision testing. Makes more strict stipulates for the head protection and safety belt system, Etc make it as the most strictest stand in the world.
Need help?
Do you have a question about the Bebe Stars Evolution and is the answer not in the manual?
Questions and answers