Removal of front support plate from wheelchair base
Preparation
Note! Switch off the wheelchair via remote control
Instructions
Note! Suitable work area required!
• Follow the illustrated instruction for removing the front support plate
from the wheelchair base.
• Rebuild the wheelchair in reverse order once completed.
Fig. 6.2.5
1. Remove bolts (A) using 5mm hex key
Tightening torque for (A) bolt is 20 Nm.
Fig. 6.2.6
2. wheel casing (B) will fall from the front support plate when bolt is
removed
Fig. 6.2.7
3. Remove bolt (C) using 5mm hex key
14
Tools used
Q50R
REV.A