Spare Parts; Maintenance＆Cleaning; Maintenance - Sunrise Medical Quickie Q50R Service Instructions Manual

4.0 Spare parts

For spare parts please refer to separate manuals.
Please only use genuine spare parts supplied by Sunrise Medical, failure to do so may result in the invalidation of your warranty.
Service technicians:
Repairs may only be carried out by trained and authorized service technicians.
During the execution of their work they are at all times fully responsible for the fulfilment of locally applicable safety guidelines
and standards.
Temporary employees and persons in training may only carry out repair and replacement work under the supervision of an
authorized service technician.
5.0 Maintenance＆Cleaning
The wheelchair's lifespan is dependent on it being well maintained.
For information concerning specific settings, maintenance or repair work, please contact your authorized Sunrise dealer. Always
be sure to mention the model, year of manufacture and identification number provided on the identification plate of the
wheelchair when contacting your dealer.
The wheelchair should be serviced by your authorized Sunrise dealer twice a year or, in the case of intensive use, every year.
For a list of approved authorized dealers in your area please contact Sunrise Medical Service Centre.
The contact details of your local Sunrise medical service Centre can be found on the back cover of this booklet.
National and International Website addresses are on the back cover.

5.1 Maintenance

• Loose fasteners should be re-tightened according to the installation instructions. Please refer (unless otherwise specified) to the
general table below for needed Torques.
Note: it will be necessary to use a torque wrench.
• Safety belt should be replaced at the first indication of damage and/or excessive wear.
• If a broken or loose component is found, discontinue use immediately and contact your authorized Sunrise Medical supplier for
replacement.
• Check all Velcro fastening straps for correct adhesion when pressed together.
• Ensure that any contamination, such as fluff hair etc is removed from the Velcro straps. Such contamination may affect adhesion
7 Q50R REV.A