Work/Operation - Fayat Bomag BP 20/50 Operating Instructions Manual

Operation
Engine "drowned"
i
Note
When the choke is closed and the starter rope is
pulled several times, the engine draws in too much
fuel and will probably not start.
Remedy
Close the fuel cock.
l
Open the choke.
l
Set the throttle lever to full speed position.
l
Operate the recoil starter until the engine
l
starts.
i Note
If the engine does not start after 10 to 20 attempts
Open the choke.
l
Set the throttle lever to full speed position.
l
pull off the spark plug socket.
l
unscrew the spark plug.
l
operate the starter several times.
l
Dry the spark plug with a clean cloth or blow it
l
dry with compressed air. If necessary clean
with a wire brush.
Screw the spark plug back in and plug the
l
spark plug socket back on.
Repeat the starting procedure.
l
30

5.5 Work/operation

Danger
!
Danger of accident!
Steer the vibratory plate only be the steering
handle.
Caution
!
Operate the vibratory plate only with full en-
gine speed, as otherwise the centrifugal clutch
will be destroyed.
For short breaks you should always return the
throttle lever to idle speed position, this avoids
premature wear of the centrifugal clutch.
Fig. 27
Shift the throttle lever (Fig. 27) in direction of
l
arrow to full load position.
The vibratory plate works with highest frequency.
BOMAG BP 20/50, BP 25/50