Checking, Tensioning The V-Belt, Replacing It If Necessary - Fayat Bomag BP 20/50 Operating Instructions Manual

Maintenance every 6 months
6.16 Checking, tensioning the V-
belt, replacing it if neces-
sary
Checking the V-belt
Fig. 56
Remove the V-belt guard.
l
Check the condition and tension of the V-belt
l
(Fig. 56), replace the V-belt if damaged.
i
Note
Compression measurement approx. 5 - 10 mm.
Changing the V-belt
Fig. 57
Slightly loosen two fastening screws (1) (Fig.
l
57) on both sides of the engine carrier.
Push the motor carrier forward and take the V-
l
belt off.
52
Install the new V-belt.
l
Tightening the V-belt
Fig. 58
Pull the engine carrier back (Fig. 58), until the
l
correct V-belt tension is achieved and tighten
the fastening screws (1).
Assemble the V-belt guard.
l
Caution
!
Check the V-belt tension again after a running
time of approx. 25 operating hours, retighten if
necessary.
BOMAG BP 20/50, BP 25/50