Nederman FlexFilter EX Instruction Manual page 33

FlexFilter EX EN
IMPORTANT! SAFETY INFORMATION
FlexFilter EX is designed for collecting and filtering combustible and non-
combustible dry dust. The filter should not be used for filtering fumes from
welding processes.
FlexFilter EX must be installed, used and maintained according to this
Instruction Manual in such a way that safety not will be neglected. The manual
contains important warning directions which have to be read and followed.
Any functional disorders, especially those affecting the safety of the machine,
must be rectified immediately.
Standards relating to the connection and use of filters in hazardous areas must
be taken into consideration, especially national standards for installation. Only
trained personnel familiar with these standards should handle this type of
filters.
FlexFilter EX is specially designed to comply with official regulations
concerning the risk of explosion. If improperly used, badly connected, or
altered, no matter how minor, the safety and reliability could be jeopardized.
Each FlexFilter EX system must be dimensioned individually. To ensure that the
system will be safe, a risk analysis must be performed for each installation and
intended use.
Grinding, welding or other hot works on the filter exterior or duct system
should not be done without first stopping and cleaning the system.
Access to the FlexFilter EX shall be restricted to authorised personnel only.
Place fire alarms and appropriate extinguishing system in all locations where
the collected dust is stored.
33