Contec F&eIT Series User Manual page 46

Table 7.7. Device Information
Address
Area
(h)
Starting
address
+0000
Device–specific
information
Starting Module settings
address
+0010
Starting Channel
address settings
+0020
CPU-CA10(FIT)GY, CPU-CA20(FIT)GY
Size Parameter
Module type (category)
Module type (serial No.)
System-reserved (revision No.)
Supported functions – supported
functions are indicated by bits (0:
off; 1: on)
D0: Basic input
D1: Basic output
D2: Expanded function
D3: Reserved
D4: Continuous input
D5: Continuous output
D6: Reserved
16
D7: Reserved
Number of basic input channels
Basic input data size
(input data size per channel)
Number of basic output channels
Basic output data size
(output data size per channel)
Input channel setup address
Input channel setup data size
Output channel setup address
Output channel setup data size
Reserved
16 Module startup register
Error status
Module-dependent
96 Module-dependent
7. Virtual Address Map
Size Remarks
1 See the hardware specs.
1 See the hardware specs.
1
1 When the expanded functions
are supported (D2 = on), the
host checks the expanded
function parameters in the
expanded function area and gets
their detailed information.
1 0 - 16
1 0 - 128
1 0 - 16
1 0 - 128
1 Fixed at 0x20
1 Data size set for each channel
1 Stores the starting position for
output channel settings.
1 Setup data size for each channel
4
1 0 : off, 1 : on
D0 : Device started/stopped
1 0 : normal operation
Non-zero : error
(Principally, a module setup
startup error is stored
here.)
14
96
39