Contec F&eIT Series User Manual page 42

Settings
The 4Kbytes (1000h) area starting from address 00001000h is used to store the settings required for
communications. Area for reading and writing settings. Settings can only be written via
communications with an ID that matches the privilege ID.
Table 7.2. Settings
Address (h) Area
00001000
Settings
*1 For security purposes, the type of the ID is distinguished, and whether the data can be read/written is determined.
(Because this is a read-disabled area, if the settings are unknown, you may need to initialize the area and perform
a setup from scratch.)
*2 Trap-to IP address: If the host with a specified IP address is started, the device-specific information will be
transmitted to it.
*3 Multicast IP1 - 4: Registers the multicast group that receives simultaneous communications by multicasting.
Statistical information
The 4Kbytes (1000h) area starting from address 00002000h is used to read the statistical data for the
device.
Table 7.3. Statistics
Address
Area
(h)
00002000 Elapsed time
Total number of transmitted
frames
Total number of transmitted
bytes
Total number of received
Statistics
frames
Total number of received bytes
Total number of errors sent
Total number of errors received
Reserved
CPU-CA10(FIT)GY, CPU-CA20(FIT)GY
Parameter
Read-privilege ID
Read/Write privilege ID
IP address
Subnet mask
Default gateway
Trop-to IP address
Effective multicast
Multicast IP1
Multicast IP2
Multicast IP3
Multicast IP4
UDP port
Reserved
Parameter
Access
Size
type
8 W *1 (Initial value: 00h)
8 W *1 (Initial value: 00h)
4 R/W Example: 192.168.132.31
4 R/W Example: 255.255.255.0
4 R/W Example: 192.168.132.1
4 R/W *2 Example: 192.168.132.21
4 R/W 0 - 4 (Initial value = 0)
4 R/W *3 Indicates a Group 3 address, to
be used for multicasting
4 R/W
4 R/W
4 R/W
2 R/W 5007h (initial value)
4042 R
Access
Size
type
4 R Seconds
4 R Counter
4 R Counter
4 R Counter
4 R Counter
4 R Counter
4 R Counter
4068 R
7. Virtual Address Map
Remarks
Remarks
35