Contec F&eIT Series User Manual page 13

1. Before Using the Product
- To avoid malfunction, please do not change the module switch settings in an unauthorized
manner.
- Do not operate the device module when the power for the Controller Module is on.
To avoid malfunction, please be sure to turn off the power for the Controller Module.
- Regarding "CE EMC Directive Notice"
Please use the STP cable to meet the mentioned standard above.
The ferrite core must be installed in LAN connecting cable.
Name
E04SR301334
E04SR170730A
* Equivalent product can also be used.
Image diagram
FCC PART 15Class A Notice
NOTE
This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference when the equipment is operated in a commercial environment.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed and
used in accordance with the instruction manual, may cause harmful interference to radio
communications. Operation of this equipment in a residential area is likely to cause harmful
interference in which case the user will be required to correct the interference at his own expense.
FCC WARNING
Changes or modifications not expressly approved by the party responsible for compliance could void
the user's authority to operate the equipment.
6
Maker Turn Quantity
SEIWA 2 1
SEIWA 1 2
Ferrite core
Cable
Installation Site
on LAN cable at product side
on LAN cable at product side
TURN: 1
TURN: 2
CPU-CA10(FIT)GY, CPU-CA20(FIT)GY
TURN: 4
TURN: 3