Contec F&eIT Series User Manual page 18

Operating modes and status indicators [Common]
Table 2.2. Operating Modes and Status Indicators
Operating Starting
mode an operation
Normal Power ON:
op. mode Reset switch ON:
Remote-reset
Initialization Power ON:
mode Reset switch ON:
(factory Remote-reset:
settings) (does not
automatically
return to normal
operating mode)
Recovery mode Power ON:
& V.UP mode Reset switch ON:
Remote-reset:
(does not
automatically
return to normal
operating mode)
Connectors
Table 2.3. Connectors
Name
UTP port Network connection port.
Communication speed: 10Mbps auto-detect [CPU-CA10(FIT)GY]
Communication type: Connected as full duplex or half duplex.
ERROR-OUT *1 Output specs: Open collector output by photocoupler insulation
Output ratings: 30VDC(Max.), 10mA(Min.)
Response time: 100µsec(Max.)
Power input 5VDC±5%
connector 2-piece detachable power input connector, FG pin
Dedicated screw-type plug that can be operated from the side
(MCS 5/3-ST-3.5 Phoenix Contact-compliant cable: AWG 28 - 16)
*1 Only on the CPU-CA10(FIT)GY.
CPU-CA10(FIT)GY, CPU-CA20(FIT)GY
Condition
of Group ID
RUN
Set to 0 - 8 or A
Continuous, alternating
"F" switch Continuous
settings flashing
"E" switch Continuous
settings flashing
Continuous
flashing
Specifications / Function
10/100Mbps auto-detect [CPU-CA20(FIT)GY]
2. Module Nomenclature and Settings
Status indicator
STATUS
ON OFF Normal operation
Resetting
flashing
OFF Continuous Abnormal conditions
flashing (e.g., memory check error)
ON ON Abnormal conditions
(e.g., start error)
Continuous Initializing
flashing
ON ON Initialization complete
(To return to normal
operating mode, change
the
GroupID and turn the
power on again or press
the
Reset switch.)
OFF Continuous Error during initialization
flashing
ON ON Abnormal conditions
(e.g., start error)
OFF Starting
Continuous Writing to firmware
flashing
OFF Continuous Write error occurred.
flashing
ON ON Abnormal conditions
(e.g., start error)
Condition
11