Configuring The Primary Base Station; Figure 22: Multi-Cell Screen (Default Values) - Uniden EXP1240 Installation Manual

Hide thumbs Also See for EXP1240:

Table of Contents

EXP1240 System Installation Guide

Configuring the Primary Base Station

You will need to perform the following steps on the primary base station only. See page

33 for information on all other base stations.

1) Place the primary base station at its final location. (See the Network Planning Guide for

information on the proper placement of base stations.)

2) Login to the base station.

3) In the left hand panel, click on

4) Set the

Multi cell system

5) In the

System chain ID

should belong to. Acceptable ID values range from 0 to 99999.

6) In the

Synchronization time(s)

base station re-synchronizes with the other base stations in this chain (if necessary).

All manuals and user guides at all-guides.com

. This opens the

Multi cell

Figure 22:

Multi-cell

field to

Enable

field, enter the unique identifier of the chain this base station

, change the number of seconds between each time this

PROPRIETARY AND CONFIDENTIAL

Multi-cell

screen (default values)

Revision 06

screen.

Page 32 of 71

Table of Contents